Laptop Computer Repair Problems That Can Be Solved Yourself

Jun.29, 2010 in Computers

Computer issues may seem extremely difficult at first impression, but some are reasonably easy to fix. You will still pay a lot to have someone fix most major issues for you, so why don’t you try and see if you can do it yourself first?

repair problems that can be handled by the average user. On a range of 1 to 10, replacing RAM is generally about a two, installing a new drive is 6 or 7, but still do-able. Replacing a video card or sound card is less than a five or six.

A word to the wise: Static electricity can ruin the circuitry inside your computer. Before you reach inside the computer, ground yourself with a grounding strap; or at the very least touch the frame of the PC first. If you don’t want to try the job yourself or are not successful then check out laptop repair Apple Valley Mn on the internet for assistance!

Below are some issues you can probably fix on your own:

1. You switch on the computer and nothing happens.The lights do not come on, it doesn’t beep, just nothing at all happens no lights, no beeps, no fan noise. What is the first thing you do? Be certain the darn thing is plugged in. Even if you are fully certain it’s connected, double check.

Assuming it’s plugged in, you most likely have a bad power supply. This is a metal box located in the top and back of the computer. It is generally held in by 4 screws and the power cable connects to it. A wiring harness exits the power supply within the PC. Countless power connectors are attached to the ends of the wires. These plug into drives, fans and probably other gadgets. The harness also will have connectors to the mainboard. It is of no consequence which wire connects where, as long as the connector fits.

When you open the computer, this mess of wiring can be exceedingly threatening. Study it, and you will find it less puzzling. Note the connections in writing, if required. Disconnect the wires and take away the power supply. Take it to the computer store and get a replacement with the same wattage. Figure on spending fifty to seventy dollars for the part. If you don’t want to try the job yourself or are not successful then check out virus removal Shakopee Mn on the internet for assistance!

2. If you constantly gives the “Blue Screen of Death”. You may have a RAM issue. Don’t bother writing down the error code on the error screen or visiting the Microsoft Help and Support data base, its a big waste of time. Instead here is the straightforward way to figure out if its bad memory.

Turn off and open up the PC and find the RAM sticks. If there is multiple, take out all but the first stick of RAM. Now plug in the computer and power it on, does it work properly? Now switch it off, take out the one stick of RAM and replace it with another. Power it up again and see if it is working. Keep doing this process with each stick of RAM one at a time. If one stick is bad, the computer possibly wont start up when that stick is in the computer on its own.

Assuming you do have a RAM issue, they are easy to mend. You could attempt swapping out memory sticks from a working computer, but be certain the RAM is the same kind to work. If that doesn’t work, bring the old memory to a computer store, they might be willing to test it, or you can test it in a mates computer yourself.

The sticks of RAM go in the sockets near the CPU, they are about 4 inches long. Take away the old memory and figure out what kind you need. Memory prices are all over the place, dependent on type and speed; ensure you get the proper type for your personal computer. When you put in the new memory into the slot, put one side in, then press down on the other. You will probably have to use light force to press it down, and the clips on each end will snap into place when the RAM stick is seated properly. If you don’t want to try the job yourself or are not successful then check out laptop repair Lakeville Mn on the internet for assistance!